Electronics & High Tech

From electronic chips and printed circuit boards (PCBs) to smartphones or computers, SimScale is the perfect tool for electronics simulation, enabling companies to ensure power optimization, durability, efficiency or thermal performance for their products. | Page 2

Simulate Heat Transfer with Motherboard,Processor and Radiator of Passive Cooling

Visualising magnetic flux fields in a custom voice coil actuator

Thermal simulation of battery pack busbars

Simulación del módulo ASPEN sin aplicar cambios

Does it flow? 

Made changes to model. Removed pins at the turn and put fins, removed some pins at the inlet and made also made inlet corners less round. 

This sim was set up with Pressure inlet + Pressure outlet. I was told that this 'boundary condition combination is very poor in terms of stability'. I don't think the data is any good? 

It is a fluid heat transfer block/water boiler block. The block goes onto heat source, water gets pumped into it, and aim is to heat up the water.

To increase the surface area there are lots of fins inside, and fluid needs to turn 180, so the fins at the turn are in a radial pattern.

I wanted to simulate the water flow to see what it might do, and see if there are any massive dead spots.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation. - Copy